Don't Spend Money Drilling a Water Well Until You Know There's Water Under Your Property!
If you've been thinking about putting a water well on your land, watch the video to see how we can tell you where the water is before you pay for a driller! You can also read the summary below.
Hi – this is Andrew Vandekop from Well Water Finders. I just want to show you a little bit about how we do a water survey. I’m going to show up at that trailer, I’m going to load my equipment onto your land over there – and then we’ll be able to tell you how much water is underneath your property. So, let’s go ahead and get started.
(music interlude while equipment is set up)
Okay, the system is set up, its active, this is the control switch, so I’m going to go ahead and start looking for water underneath your land.
(sound effects during demonstration of test)
So, here’s how our patented system works. We’ve sent 20 EM signals in the ground and we’re going to look at the results. So, come take a look and I’m going to explain how it works.
When we pass through an area where’s there no water, the signal comes back fairly clean. As you can see here where the variance is, that’s caused by going through a layer of water. And in this scenario we were looking for a shallow ag well for a gentleman, and by far this site – Site 5 – is the best place. There’s a couple of spots if you’d drill they’d be dry, there’s a couple of spots that have a little bit of water but Site 5 would be the place if you want to put in a shallow well for his cows – that would be the place to do it.
So that’s how our system works. I can deploy it in about 15 minutes, I can tell you the water layers underneath your property, and the bonus of our patented system is it can go 6,000 feet down. So if we see signs in Oil & Gas, we’ll also let you know that in the final report.
If you have any questions contact me at andrew@wellwaterfinders.com. Thank you very much!
